Changed location of wiring exit from base of mast; enlarged drain slot

The old hole was on the port side, which is the inaccessible side of the mast in the bilge. Jonny drilled a new hole on the starboard side; the edges were filed nicely to create a soft edge for the wiring to exit.

The old drainage at the base of the mast was a single hole, approximately 1/8″ in diameter, about 2″ above the base of the mast. This was corroded and plugged when we pulled the mast, and the base was filled with dirt and aluminum corrosion. Jonny used a cutoff blade on the grinder to create a narrow slot from the base, reaching up to the old hole. This should do the job much better.